|
This is a 2 yard
Multi-Purpose 1 to 4 Skeins Skein Winder/Blocker. When
you are ready to take the skeins off just pull the pins and that
will release the skeins so you can take them off easily.
Assembly
Instruction.
Put one end of
the base on the floor and put the two longest pipes in the elbow and
then attach other end. Put on table and level base.
Put the end with
the cross on the floor and insert parts per picture. Be careful not
to bend the cup hooks.
Assemble to axle
with the cross going to the handle on the axle. At the cross end clip
put the bolt with the washers through the clip and into the cross
Put on the washer and nut. Insert the two pull
pins per picture.
Put a couple
drops of OIL where
the axle turns.
Options
Motor Group
It hangs on the frame to the right of the handle. Put drive band on
the cup hooks and the pulley of the motor and line up the motor with
the hooks. Plug cord into the motor then into the wall outlet.
Use the foot controller to run the motor
Yardage Counter
is a good option.
|
