Yarnblocker - Two Yard.

1. Put all the parts in the box on the floor.

2. Set the two parts that have the elbows facing each other.

3. Set the two base tube in place and tap the end so the tubes are all the way in the elbows.

4. Put the axle support tubes in place using the axle to line them up.  I think the handle is on the opposite end than the picture.
   

5. Put the long tubes on the axle.  Line up marks on the axle.  Put the part with the screw in it on first.

6. Install the metal bracket.  The bolt should go so that it squares up the frame.
   

7. Put the tubes on the ends.  Tight and square everything in place