<!-- @page { margin: 0.79in } P { margin-bottom: 0.08in } -->

HH Electric Wonder Tension Assembly Instructions.

1. Unpack box and put parts on table as pictured.

2. Hang drive band over orifice bearing tube.

3. Put flyer in place.

4. Put on leather wonder tension band. This goes on the end of the flange of the bobbin. Put one end of the leather band with Velcro on each side on the frame. This is what causes the yarn to wind yarn on the bobbin as it slows the bobbin down so the flyer can warp the yarn on the bobbin.

5. Plug in the cord dimmer into the 110 volt outlet and then plug the foot controller into the cord dimmer plug.

6. Plug the special plug from the foot controller into the motor being sure to line up the groves and pins correctly.

7. Mount motor so the pulley is facing the rear of the spinner which is the spin side. When you want to ply move the motor to the right side, the ply side.

8. Put drive band on pulley of motor and then on the whorl on the flyer. Line up motor and drive band with the whorl by moving the motor.

9. OIL at each of end on the bobbin at the brass tube, oil the bearing tubes that hold the flyer and also keep the wonder tension leather band where it connects with the bobbin soft with oil. If machine starts to pull in too fast for you oil the leather band. Do not over oil as a little will last a long time. Use sewing machine oil.

10. To put on a new leader on a new bobbin, just hold one end of the leader on the Babe Aid Velcro black dot on the bobbin and turn bobbin to the left over wrapping the Babe Aid several times. You do not need to tie the leader on. Then use the orifice hook to tread the leader through the sliding hairpin clip, through the hook and out the orifice.

11. Now you are ready to start spinning yarn and have fun

12. Use the cord dimmer to control the speed you want to always go at. Then use the foot controller to get started until the cord dimmer takes over. You can use it with out the cord dimmer if you like.