Unpack box and put parts on table as pictured.

Hang drive band on bobbin that is on flyer and put flyer in place.

Put leather brake on flyer between flyer and orifice bearing tube and pull down the leather brake ends and attach to Velcro.

Line up motor pulley with the whorl on the bobbin. Put drive band on the pulley of the motor and then on the whorl of the bobbin. Motor should be attached to the spin side of the base (right side). Motor goes on the left side of base for plying.

Attach cord to motor and then plug it into the lamp dimmer and then plug the lamp dimmer into the 110 volt electric outlet.

To assemble the LK and SW. Into the base insert the counter tube assembly like in picture. Knob on counter resets it back to zero.

For SW insert two of the matching arms opposite each other in the cross fitting, and then the other two arms opposite each other. Be sure they are all the way in.

Put SW into the Tee of the counter assembly.

Put the LKs (stainless steel wire U shape form) in from the bottom of the LK.

Oil where the Bobbin turns on the Flyer and also the bearing tube where the flyer spins. If the oil gets on the leather brake it will not hurt anything.

Read Spinning on a Babe or other book on spinning and you are ready to get started.

Have fun spinning yarn.